Diabetes Electrifier InstructionsInstall batteries: Remove the back cover using a small phillips screwdriver. Attach four 9 volt alkaline batteries to the battery clips. Be sure not to pull on the battery wires since they are a small gauge wire and not made to be pulled on. Click here to see correct battery placement. Put the bubble wrap on top of them (to keep them from being able to move around) and screw on the lid.
The
research indicates that at least 3.5 hours
a day of low frequency/low current treatment creates antioxidants in
the body that help to restore the blood sugar regulation in diabetic
patients. It also reduces high blood pressure. The supplied
self-adhesive electrodes can be used for this purpose. They can be
stuck to your two feet while you read or watch TV, or while you sleep.
For overnight use I'd recommend using elastic wrap to keep them in
place since they aren't highly sticky. When they start losing their
stickiness after a weeks usage you can put water on the sticky side so
it will be absorbed there and rehydrate the glue.
USAGE
Just switch to "Low" and place the electrodes on your body. Then switch
the unit on. The current dial has no effect in this position. At "Low"
the frequency is .00073Hz and the current output is around 100nA. The
10Hz switch position is for blood electrification and infection/wound
treatment as is explained below.
Blood Electrification
The idea behind these instructions is to give you a guideline for
amount of usage to match your body's amount of resultant cleansing
so that you don't try to do too much too soon and get sick from
excess cleansing. The immune system & liver & kidneys will
cleanse the blood of deactivated viruses/bacteria/yeast but only at
a rate that is unique to you. Therefore you should start out slowly
and every week increase usage time if you feel up to it. If you
have a Magnetic Pulser then use it first and don't start using the
Microbe Electrifier till you stop getting major cleansing reactions
from the Pulser.
It normally takes people 6-8 weeks to complete blood electrification treatment although circulation impaired people and
people with CFIDS, AIDS, and other immune dysfunction diseases often
have to progress (increment the usage time weekly) more slowly.
Precautions: It's best to do blood electrification
first thing in the morning and even better if before eating
anything. In the morning is when the blood is the cleanest.
Protocol: Start by using the blood electrification for 15 minutes.
If the next day you don't feel very toxic (with
headaches, tiredness, achiness, etc) then increase your usage time
by 5 minutes. But if you get excess cleansing reactions then lessen the
treatment time to 5-10 minutes. To aid the body expel the trash from the
bloodstream you can drink a lot of water or celery
juice and take as a diuretic parsley tea, watermelon, or cucumber.
Your cleansing reactions determine the pace you need. It's normal to be able to
increase your usage time once a week (if
you're not having excessive cleansing reactions). Don't go so fast
that you overly sicken yourself with excess cleansing reactions. If
you don't start out slow the first 2 weeks then you may overly
lower your immune system from die-off so that you could get sick from some
infection. I know of 2 people who used theirs for 1 hour
daily the first week and wound up getting pneumonia. Haste makes
waste. Do enough time so that you feel cleansing reactions but
don't overdo it. If you have an almost non-functioning immune
system and don't experience any cleansing reactions then take an herbal immune booster
such as Beta Glucan from www.nsc24.com to
increase your immunity.
If you've used the device for 2 months and you are still getting
cleansing reactions from it then you should continue using it daily
until you no longer get those reactions and then for one more week for 2-3 hours daily (1 in the morning and 1-2 at night).
Make sure blood electrification is done every day without skipping
any. AIDS patients need to use it the same time every day (+/-
2hrs) because HIV has a 1.2 day life cycle. For viral infections,
if you skip a day then you'll have to continue using it for at
least 21 days from that skipped day because of the 21 day life
cycle of most viruses. Don't skip a day! If you are taking potent
drugs and/or herbs more than once a day or are generally toxic due
to poorly functioning kidneys then use the 40 hz setting to avoid
transfection effects.
Positive Thinking: It may be helpful if you encouraged
yourself daily to resist the tendency to become skeptical and give
up. Do this by thinking positive thoughts about the new life you'll
have once you've regained your health. It will be definitely worth
any trouble encountered. Life can be so sweet when vitality
brightens every moment of your existence.
Blood Electrification Instructions
To test for proper operation and strength of batteries: Flip the
power switch to the ON position and the frequency switch to 10 hz.
Press the Test button down and look at the Test Light to see that the two green lights are both blinking. If the four
9 volt batteries need replacement the Test Light will not light at
all. To replace the batteries just use a Phillips screwdriver to
unscrew the cases bottom 4 screws, pull off the cover, and then
pull off the snap clips from each battery so that they can be
replaced with new alkaline ones. Reinstall the padding as it was so
as to prevent the batteries from rattling when the box is
jiggled.
Choosing electrode site: Both electrodes on the inside of
one wrist is the easiest site for convenient usage, but it affects
the least amount of blood and requires turning up the current to a very
uncomfortable level for enough current to travel in the arteries
instead of just crossing the wrist. This would only be advised for
one-armed people. Using one electrode on one wrist
and the second one on the other wrist is my favorite way because plenty
of blood is affected. Using the electrodes on both ankles affects the
most
amount of blood, but will barely allow enough electrical current
for some people (due to mineral deficiencies) and is hardest for
initiating and maintaining correct electrode placement.
Locating electrode placement sites for one wrist: The
locations on the two main arteries is on the inner side of either
wrist about 1+1/2 inches below the wrist crease to the outside of
the main tendons, between them and the bones. Over these arteries,
starting about 1" from the crease, is where the electrodes should
be placed. (Avoid placing electrodes directly over the thumb side
tendon to prevent muscular twitching during use.) The placement
site for the little finger side is actually more on the side of the
wrist. (picture)
Locating electrode placement sites for both wrists: The
locations are the inner side of the wrists about 1+1/2 inches below
the wrist crease to the outside of the main tendon on the little
finger side or thumb side. Each wrist should have one electrode
held in place by one wrist band. (picture) This is the
most preferred electrode placement.
Locating electrode placement sites for ankles: On the inner
side of each foot locate the pulse of the unseen artery between the
ankle and the heel. If you can't feel it then go for a brisk walk
for ten minutes and then feel for it without elevating your foot.
On top of these pulsating arteries are the sites. (picture)
Connecting Electrodes: Clean & dry the electrode sites. Soak each
of the cloth electrodes thoroughly with tap water or saltwater. Squeeze the middle of the insulation of the
alligator clips (at the end of its wires) so that you open the jaws
and then let them bite onto the electrodes ends. (picture)
Place the electrode over the artery.
Then put the elastic band around it and the wrist. Don't
pull it tight. Just enough stretch to keep it in place is good.
If using electrodes on the ankles, then attach them there with 1" wide
medical tape. Re-wet the cloth electrode after 1 hour of use if the .19mA current light can't be maintained on.
Making Saltwater: If your tap water isn't very electrically
conductive then you can make some saltwater by putting a couple of shakes of
salt from the saltshaker into a cup of purified water and stirring it. This is very electrically conductive but
also very corrosive to the alligator clips.
Using the device: Connect the wet electrodes to you. Turn
the current control dial fully counter-clockwise, set the unit to 10hz, and flip
the switch to the ON position. Turn the current dial clockwise until the current
light comes on fully. The current light will indicate when you are getting .19mA (190ua) through your
bloodstream. If
it won't light at maximum dial position then one of three
conditions exist; 1) Your body's salt & mineral level is very
low, 2) Where you placed the electrodes is unsuitable, 3) You need
to use saltwater on the electrodes instead of tap water.
If your body's salt level is low then start salting your food with
sea salt (which doesn't cause high blood pressure). If the
electrodes 'sting' or 'bite' then 1) the current dial setting is too high, 2)
your skin is dirty, 3) you need to relocate the electrodes.
Comfort Suggestions: If the elastic strap is too tight it
will leave ridges on the skin when taken off. You can also sew
something soft onto the inside of the band (if a natural fiber then
not where the electrodes will be because natural fibers will wick
away the electrodes moisture). If your skin becomes irritated where
the electrodes touch then maybe you're applying too much current or you should
place the electrodes on the ankles instead of the wrists.
Pad Electrode Usage: You can use the provided pad electrodes (or
anything else made of 100% cotton)
for
treating any injured or infected area of the body (ie: gastritis,
hepatitis, stomach virus, infected wound, sore throat, etc) by letting
the
electricity affect the area of the body that is between the two
pads. That is what is meant by "localized treatment". To use them,
first put the 3" square cloth pad electrodes into tap water
until fully wet, then lightly squeeze out the excess. Connect each
alligator
clip onto the edge of each pad so that one of the 'jaws' is
sandwiched inside the pad. Repeat for the second pad
and alligator clip. Place them on your body so that the infected
area is between them. Hold them in place with elastic or with
plastic if you are holding them with your hands. Then with the
frequency switch set
to 10hz, and the current control dial (left side) fully
counter-clockwise, turn the unit on and move the
current control dial clockwise until you begin to feel an electrical tingle.
Treat for
at least 30 minutes a day. Click
here to read more about electricity promoting healing.
Click here for instructions on treating hepatitis.
|